|
|
|
|
With the inconsistency that Soap and Water has as an application fluid, we have chosen to become a Rapid Tac application fluid dealer so that our customers have consistent results with applying their decals. Now you can place decals down like a pro and have the confidence that they will adhere to the surface the first time without any future problems like soap bubbles or pulling the decals back off because it will not adhere with soapy water or other homemade concoctions. 
The Original Rapid Tac
For fast, easy, quality installation of graphics with no bubbles, even in cold weather. This environmentally friendly product is great for installing decals and vinyl graphics. Granted, not all applications call for a "wet" procedure, but we do know that most of our customers want to use a wet application method since their limited experience can lead to some wrinkles and bubbles if applied dry. By using Rapid Tac application fluid a novice can apply graphics with the end result looking professional. Sometimes one person can do a job (normally requiring two people to apply dry) in less time if an application fluid like Rapid Tac or new Rapid Tac II is used. (Rapid Tac II bonds faster than Rapid Tac, and is intended for films with a lower tac adhesive than premium vinyl.) Application fluid cleans without leaving residues. It then helps to "float" the vinyl until it is properly positioned. Best of all Rapid Tac and Rapid Tac II stimulates the adhesive to bond in approximately ninety seconds, even in adverse climates such as extreme hot or cold. It will not cause bubbles so there's no returning to poke holes in your work either.
New Rapid Tac II will enable you to perform wet
applications with a wider variety of film types (Intermediate, Cast, Economy,
Calendared, Metallic, Reflective, Polyester, Mylar).
This environmentally friendly product is great for removing adhesive glue left over by decals and vinyl graphics. Rapid Remover is a non-toxic, water-soluble that breaks down and removes adhesives in sixty seconds! You spray it on, wait thirty to sixty seconds, and easily wipe it off with a plastic squeegee, with no damage to painted or bare metal surfaces. What may have been a four-hour job (and a messy one at that) can now be done in one and half-hours: an easy, clean and non-damaging removal.
STEP 1. Remove decal with heat
lamp or heat gun.
STEP 2. Spray glue
residue with Rapid Remover and let
penetrate for30-60 seconds.
STEP 3. Using a
squeegee, scrape to remove glue residue.
STEP 4. Spray
Rapid Remover on a paper towel and wipe
surface clean.
STEP 5. Rinse
surface with Rapid Remover Application
fluid or water. Product is water-soluble.
|
|
|
Business Hours M-F 9:00AM - 5:00PM
Central Time Fax 573-368-3800
The original designs, images, logos and all artwork pictured on this website is the exclusive property of Aero Graphix and is protected by Federal Copyright Laws. Any Reproduction of designs, images, logos and all artwork similar to the one's embodied herein is expressly forbidden. Should such design, construction and selling occur, Aero Graphix is due a minimum of $500 as compensation for the time, effort in creating each individual design(s) per Federal Law 17 U.S.C. Section 101 et seq. and could be liable for statutory damages as high as $150,000 as set forth in Section 504 (c)(2) therein. Designs can be purchased for use at a one time fee set by Aero Graphix. Aero Graphix reserves the right to substitute products of like kinds and quality as it deems appropriate in the manufacturing of said displays. |
